Kasutusjuhend Stoves 1000 Köögi õhupuhasti

Kasutusjuhend

INSTALLATION INSTRUCTIONS

• Assembly and electrical connections must be carried out by specialised personnel.

• Wear protective gloves before proceeding with the installation.

• Electric Connection:

- The appliance has been manufactured as a class II, therefore no earth cable is necessary. The power point

must be easily accessible after the installation of the appliance. If the appliance is equipped with power cord

without plug, a suitably dimensioned omnipolar switch with 3 mm minimum opening between contacts must be

fitted between the appliance and the electricity supply in compliance with the load and current regulations.

- The connection to the mains is carried out as follows:

BROWN = L line

BLUE = N neutral.

• If the hob is electric, gas, or induction, the minimum distance between the same and the lower part of the

hood must be at least 65 cm. If a connection tube composed of two parts is used, the upper part must be

placed outside the lower part.

Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating

fumes from other appliances generated by other than an electrical source.

Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.1) so that the unit is

easier to handle.

- In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air.

Fig.1 Fig.2

• We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If

a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may

become noisier.

• If your appliance has been designed for use in habitations supplied with a centralised suction device perform

the following operations:

- The switch controls opening and closure of a valve using a thermo electrical device. By placing the switch in

the ON position, after a minute, the valve opens rotating 90° allowing suction of the stale air. By placing the

switch in the OFF position, the valve closes after 100 seconds.

• Fixing to the wall:

Drill the holes A respecting the distances indicated (Fig.2).

Fix the appliance to the wall and align it in horizontal position to the wall units. When the appliance has been

adjusted, definitely fix the hood using the screws A (Fig.3). For the various installations use screws and screw

anchors suited to the type of wall (e.g. reinforced concrete, plasterboard, etc.).

If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall

EN-4

Hinnang

Lisateavet selle juhendi kohta

Mõistame, et on tore, kui teil on teie Stoves 1000 Köögi õhupuhasti jaoks paberjuhend. Juhendi saate alati meie veebisaidilt alla laadida ja ise printida. Kui soovite originaaljuhendit, soovitame võtta ühendust ettevõttega Stoves. Nad võivad anda originaaljuhendi. Kas otsite oma Stoves 1000 Köögi õhupuhasti kasutusjuhendit mõnes muus keeles? Valige meie kodulehelt oma eelistatud keel ja otsige mudelinumbrit, et näha, kas see on meil saadaval.

Tehnilised andmed

Kõik Stoves Köögi õhupuhastid kasutusjuhendid
Veel Köögi õhupuhastid käsiraamatuid

Korduma kippuvad küsimused Stoves 1000 Köögi õhupuhasti kohta

Meie tugimeeskond otsib kasulikku tooteteavet ja vastuseid korduma kippuvatele küsimustele. Kui leiate meie korduma kippuvates küsimustes ebatäpsusi, andke sellest meile teada, kasutades kontaktivormi.

Seotud tooted

Kasutusjuhend

Stoves 1100 Köögi õhupuhasti

Kasutusjuhend

Stoves 900 Köögi õhupuhasti

Kasutusjuhend

AEG DBE5671R Köögi õhupuhasti

Kasutusjuhend

AEG DVE5971HB Köögi õhupuhasti

Kasutusjuhend

Franke FTC 512 XSL Köögi õhupuhasti

Kasutusjuhend

AEG DBE3650R Köögi õhupuhasti

Kasutusjuhend

AEG DGK5861HR Köögi õhupuhasti

Kasutusjuhend

AEG DBE3651R Köögi õhupuhasti

Seotud kategooriad